VideoRay Cockpit Software Installation

VideoRay Cockpit is installed at the factory on new Pro 4 Ultra Systems. VideoRay Cockpit does not need to be installed unless the software has been deleted, or the software is being installed on a new computer.

VideoRay installation software components are stored on the computer in the C:\VideoRay\Installs\ folder, and the latest versions are available online at: https://download.videoray.com/ or through their respective vendors' websites.

The VideoRay Pro 4 Ultra Control Panel requires the installation of a serial communications hardware driver and a video capture hardware driver on the computer. These hardware drivers can be found on the local machine or online in the above referenced areas.

In addition, the VideoRay Cockpit application requires the following prerequisite software: .Net Framework 4, DirectX and SlimDX. There are two versions of the installation package. One package includes the full installation has the prerequisites included, and one does not. If the software is being installed on a computer for the first time, the package with the prerequisites must be used. If VideoRay Cockpit has been installed previously, the package without the prerequisites can usually be used. In some cases there may be updates to the prerequisite requirements, and they will need to be updated.

The installation package with the prerequisites is typically much larger and takes much more time to download than the version without the prerequisites. If you are downloading software and do not need the prerequisites, use the installation package that does not include the prerequisites.

First Time Installation

If the computer has never had VideoRay Cockpit installed, the hardware drivers and the full installation package are required.

The drivers and application installation packages should be copied to the computer on which VideoRay Cockpit is to be installed. Once copied, unzip each package and run the setup program. Follow the prompts to complete the installation of the topside software.

Once the topside software is installed, the firmware and systems tuning parameters on the ROV will need to be updated. Continue the installation process by following steps 5 - 7 in the Software Updates section of this guide.