Horizontal Thruster Cone Assembly Removal Procedures

Time required for this step: Approximately 3 Minutes (6 Minutes for both sides)

Tools required for this step:

Strap Wrench or Rubber Coated Pipe Pliers

Parts involved in this step:

HT-002-GY-ASSM Horizontal Thruster Cone Assembly

Quantity	Part Number	Part Description
1	HT-002-GY-ASSM	Thruster Assembly Horizontal Cone (Pro 4)
1	OR-135	O-Ring #135

Steps

Note: The following step-by-step instructions apply to one side. Repeat these steps on both sides if you plan to remove both Horizontal Cones.

Unscrew the horizontal thruster cone assembly from the horizontal thruster tube.
If you plan to replace the O-ring, remove it by pinching it around the horizontal thruster tube to create a slack section that can be grabbed. Do NOT use a metal tool to remove the O-ring.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Tips

The horizontal thruster cone assembly has right-handed threads. Turn the thruster cone counterclockwise, when viewed from the rear of the ROV, in order to loosen it.

If you cannot loosen the horizontal thruster cone assembly by hand, you can use a non-slip pad, strap wrench or rubber coated pipe pliers.

[ Help us improve this document ]

[ Print this page ]