Diagnostics and Repair - System Start Up

When VideoRay Cockpit starts up, it checks the hardware configuration to detect three required items:

• Video Interface
• Communications Interface
• Hand Controller

If any of these items are not detected, VideoRay Cockpit will display an error message and will not operator correctly until the configuration issues are corrected.

In each case, the first thing to check is that the appropriate cable is plugged in. For the first two, the USB cable from the computer to the control panel must be plugged in. For the hand controller, its USB cable must be plugged into the computer or one of the ports at the rear of the control panel.

Additional details about diagnosing each one of these items are provided in the following sections.