Wide Area Search (WAS)
Standard Operating Procedures
Overview
Step-by-Step
Overview
> Working without a Chart
Introduction
Copyright
Language Support
Table of Contents
About this Document
Customize this Document
How to Get Help
Before Contacting Support
Overview
Working without a Chart
Step-by-Step
1 Mission Planning
1.1 Obtain a Chart
1.2 Load the Chart
1.3 Set Up Video Overlay
1.4 Set Waypoint Defaults
1.5 Define Search Parameters
1.6 Place a Region
1.6.1 Set the Region Coverage
1.7 Save the Mission Plan
2 On-site Operations
2.1 Site Selection and Set Up
2.1.1 Begin the Predive Checklist
2.1.2 Initialize the Recording
2.1.3 Launch the Vehicle
2.2 Open Mission Controls
2.3 Start the Recording
2.4 Conduct the Mission
2.4.1 Start the Mission
2.4.2 Fine Tune Settings
2.4.3 Monitor the Sensors
2.4.4 Evaluate for Objectives
2.4.4.1 Looking for an Object
2.4.4.2 Clearing an Area
2.4.4.3 Mapping an Area
3 Vehicle Recovery
3.1 Return to Launch Site
3.2 Stop the Recording
3.3 Save the Mission
3.4 Recover the Vehicle
4 Post Mission
4.1 Analyze the Data
4.2 Archive the Data
Checklist
VideoRay Documentation Only
[
Educational Resources Library
]
[
Help us improve this document
]
[
Print this page
]
Working without a Chart
Wide Area Search (WAS) Standard Operating Procedures, Version: 1.01.00
