Rear Dome Replacement Procedures

Time required for this step: Approximately 3 Minutes

Tools required for this step:

• O-Ring Lubricator

Parts involved in this step:

MHU-004(r) Rear Dome

Steps

1. Use a new lubricated o-ring, or remove and lubricate the existing o-ring, and install it in the o-ring groove of the rear hull ring.

2. Orient the rear dome so that the tabs horizontally so that they will not interfere with the main hull rods, skid or float block when these components are installed.

3. Being careful not to pinch the O-ring, press the rear dome onto the rear hull ring until is seats against the hull ring.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Tip

The front and rear domes are the same. If the front dome is mildly scratched or marred, you can replace it with the rear dome.