LED Light Reflector Set Replacement Procedures

Time required for this step: Approximately 5 Minutes (10 Minutes for both sides)

Tools required for this step:

• #1 Phillips Head Screw Driver

Parts involved in this step:

MAR-002-ASSM LED Light Reflector Set

Steps

Note: The following step-by-step instructions apply to one side. Repeat these steps on both sides if you are replacing both LED Light Reflector Sets.

1. Orient the LED reflector so that the straight edge is parallel with the LED array, and the reflector surface is facing toward the LED array .

2. Replace the 2-56 X 1/2 inch Phillips head LED reflector screws from the rear of the LED light module assembly into the LED reflector and tighten the screws.

3. Repeat this process for the other LED reflector.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view