LED Light Reflector Set Removal Procedures

Time required for this step: Approximately 5 Minutes (10 Minutes for both sides)

Tools required for this step:

• #1 Phillips Head Screw Driver

Parts involved in this step:

MAR-002-ASSM LED Light Reflector Set

Steps

Note: The following step-by-step instructions apply to one side. Repeat these steps on both sides if you plan to remove both LED Light Reflector Sets.

1. From the back side of the LED light module assembly, unscrew the two 2-56 X 1/2 inch Phillips head LED reflector screws that hold each LED light reflector in place.

2. Remove the LED light reflectors from the LED light module assembly.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view