Pressure Sensor Kit Removal Procedures

Time required for this step: Approximately 5 Minutes

Tools required for this step:

• 3/4 Inch Open End Wrench

Parts involved in this step:

VR-PRO4-15-0001 Pressure Sensor Kit

Steps

1. Using the 3/4 inch open end wrench, unscrew the pressure sensor 1/4 inch PTFE nut from the top of the pressure sensor.

2. Remove the upper spacer from the top of the pressure sensor.

3. Pull the pressure sensor assembly from the inside of the main hull.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view