Command: vr_refresh
The vr_refresh command is used to update the firmware on a module.
Use
vr_Refresh [OPTIONS] [SINGLE_HEX_FILE_NAME]
- [Options] - See the table below
- [SINGLE_HEX_FILE_NAME] - The file name of the firmware update, including its path.
| OPTION |
Alternate |
Argument(s)
| Description |
Default |
| -? |
--help |
|
Display this help information |
|
| --version |
|
|
Display the Version Number |
|
| -c |
--com |
Com_Port_Name |
Com port to use |
dev/ttyUSB0 |
| -i |
--id |
Node_ID |
Node ID of the Module to update, use 255 for broadcast to all nodes |
255 |
| --sn |
|
Serial_Number |
The Serial Number |
any |
| --block_size |
|
Block_Size |
The block size of the firmware |
1024 |
| --timeout |
|
Timeout |
Set the connection Timeout in mS |
1500 |
| --skip_bootcheck |
|
|
Skip sending a bootcheck command |
|
| --skip_initial_reset |
|
|
Skip sending an initial reset command |
|
| -v |
--verbose |
|
Output verbose diagnostics |
|
| -r |
--reset |
|
Reset device upon completion |
|
| --UNLOCK |
|
|
Allow programming of the bootloader |
|
| ---input_file |
|
Filename |
The file name of the firmware update file, including its path |
|
 Some of the options use two dashes "--," not a long dash
|
