Horizontal Thruster Motor Mount Replacement Procedures

Time required for this step: Approximately 5 Minutes (10 Minutes for both sides)

Tools required for this step:

Parts involved in this step:

MAR-004 Horizontal Thruster Motor Mount

QuantityPart NumberPart Description
2)MAR-004Thruster Part Horizontal Motor Mount (Pro 4)
2)GTO-018Thruster Part GTO Motor Shield Brushed (GTO, Deep Blue)
8)92000A116Screw M3 x 0.5mm x 6mm Pan Head Phillips SS

Steps

Note: Both the left (port) and right (starboard) Horizontal Motor Mounts must be replaced. Repeat these steps on both sides.

  1. Orient the horizontal motor mount so that the open end is facing toward the shaft end of the horizontal thruster motor assembly.

  2. Slide the horizontal motor mount over the horizontal thruster motor shaft and onto the horizontal thruster motor assembly.

  3. Align the screw holes of the horizontal motor mount and horizontal motor assembly. Note the hole pattern is diamond shaped, not square.

  4. Replace the screws through the motor mount into the motor and tighten the screws.

If the video above doesn't play in your browser, click this play icon to try an alternate method: ,

or click this manual reference icon to view an exploded view


VideoRay Documentation Only

[ Help us improve this document ]

[ Print this page ]

Pro 4 Maintenance Manual, Version: Advanced 2.00.00
Copyright © 2019, VideoRay LLC - The Global Leader in Micro-ROV Technology