Comprehensive Parts List for:

ROV Power Control Printed Circuit Board

The following list is provided to identify all of the parts that will be involved in the process of removing and replacing the ROV Power Control Printed Circuit Board. Replacing these parts with new parts is not required unless it is determined that a part is not suitable for reuse. VideoRay recommends that new O-rings be used whenever possible.

FB-001-KIT-P4 Float Block Kit

SK-PRO4-KIT Skid Kit

GTO-006L-KIT~GTO-006R-KIT Horizontal Thruster Propeller Kit (Left and Right)

VR-PRO4-08-0001 Horizontal Thruster Nozzle Kit

MHU-002-GY-KIT Dome Retaining Rings and Main Hull Rods

MHU-004(r) Rear Dome

MHU-003-GY-KIT Rear Hull Ring Assembly

TLK-005-300-CN Desiccant Pack

CB-01-PRO4-SET ROV Board Set

PRO4-SUB-CPU19 ROV CPU Printed Circuit Board

MAR-PCB6 ROV Heat Sink

PRO4-SUB-POWER ROV Power Control Printed Circuit Board

This list includes quantities for both sides where applicable. With the exception of the horizontal thruster propellers, parts can be interchanged between left (port) and right (starboard) sides.