Horizontal Thruster Tube Removal Procedures

Time required for this step: Approximately 5 Minutes (10 Minutes for both sides)

Tools required for this step:

9/64 Inch Allen Wrench

Parts involved in this step:

HT-001-GY Horizontal Thruster Tube

Quantity	Part Number	Part Description
1	HT-001-GY	Thruster Part Horizontal Tube (Pro 4)
1	MHU-006	Thruster Part Horizontal Tube Spacer
2	OR-122	O-Ring #122
1	HT-003	Thruster Part Horizontal Tube Spacer (Inside Main Hull)
2	91274A064	Screw #8-32 x 3/4" Socket Cap Steel Ultra Corrosion Resistant
2	98370A011	Washer #8 x 0.075" Flat SS

Steps

Note: The following step-by-step instructions apply to one side. Repeat these steps on both sides if you plan to remove both Horizontal Thrust Tubes.

From inside the main hull, remove the two 8-32 X 3/4 inch socket cap screws that hold the horizontal thruster tube to the main hull tube.
Remove the horizontal thruster tube from the main hull.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

[ Help us improve this document ]

[ Print this page ]