Camera Mount Base Assembly Replacement Overview

Skill level recommended: Advanced

Total time required: Approximately 47 Minutes

Tools required:

• #2 Phillips Head Screw Driver
• #1 Phillips Head Screw Driver
• Soldering Iron
• Solder
• O-Ring Lubricator
• Lint-Free Tissue or Rag
• 7/16 Inch Open End or Socket Wrench

The following components must be replaced:

• Camera Mount Base Assembly
• Camera Tilt Servo Motor Assembly
• Camera Interface Printed Circuit Board
• Camera Assembly
• Front Hull Ring Assembly with Camera
• Horizontal Thruster Motor Assembly
• Horizontal Thruster Motor Mount
• Horizontal Thruster Cartridge Seal
• LED Light Mount
• Vertical Thruster Propeller Kit
• Skid Kit
• Float Block Kit