Main Hull Tube Removal Overview

Skill level recommended: Advanced

Total time required: Approximately 86 Minutes

Tools required:

• #2 Phillips Head Screw Driver
• 7/16 Inch Open End or Socket Wrench
• 5/16 Inch Open End Wrench or Nut Driver
• 5/16 Inch Open End Wrench or Nut Driver (Additional)
• Wooden Dowel Rod 3/8" x 12"
• Dental Pick or equivalent
• 3/4 Inch Open End Wrench
• 11/16 Inch Open End Wrench
• 1-1/4 Inch Open End or Deep Socket Wrench
• 9/64 Inch Allen Wrench

The following components must be removed:

• Float Block Kit
• Skid Kit
• Vertical Thruster Propeller Kit
• Vertical Thruster Splitter
• Vertical Thruster Cartridge Seal
• Strain Relief Cable Kit
• Light Dome
• LED Light Module Assembly
• Horizontal Thruster Propeller Kit (Left and Right)
• Horizontal Thruster Nozzle Kit
• Dome Retaining Rings and Main Hull Rods
• Front Dome
• Front Hull Ring Assembly with Camera
• Rear Dome
• Rear Hull Ring Assembly
• Desiccant Pack
• ROV Board Set
• Camera Ribbon Cable
• Termination Block and Accessory Port
• Pressure Sensor Kit
• Vertical Thruster Kit
• ROV Wire Harness
• Horizontal Thruster Tube
• Main Hull Tube