VideoRay Manipulator Operating Tips

The Manipulator is easy to mount and use.

Hardware Set Up

1. Mount the inner clamp on the skid using the supplied screws.

2. Place the manipulator in the clamp and install the outer clamp using the supplied screws.

3. Remove the 9 Pin Accessory Port Dummy Plug from the Accessory Port.

4. Install the 9 Pin connector from the Manipulator into the Accessory Port.

Operation

Use the buttons on the hand controller to open or close the manipulator.

The manipulator instrument will indicate the status of the manipulator activity.

This equipment is optional and may not be included in all VideoRay Pro 4 configurations.