If you do not see a menu here,
please allow blocked content
to enable scripts, which are
required to display the menu.


DOWNLOADS | TRAINING | SUPPORT | COMMUNITY | FAQ | BLOG | GALLERY
PRO 4

Accessories Guide - Categories - Propulsion - Hull Inspection Stabilizer

VideoRay Ship Hull Inspection Stabilizer Operating Tips

The Hull Inspection Stabilizer is easy to mount and use.

Hardware Set Up

  1. Remove the float block retaining screw and washer. Save the screw and washer for reuse without the Hull Inspection Stabilizer

  2. Install the Hull Inspection Stabilizer on top of the float block with the vertical thruster hole aligned. The bottom of the stabilizer has a contoured cut out that matches the top of the float block shape.

  3. Install the longer float block retaining screw that came with the stabilizer.

Operation

When using the Hull Inspection Stabilizer, the Controller Sensitivity can be set to custom values to improve the effectiveness and ease of use. The following settings are recommended for starting.

Surge (Forward and Reverse)100
Yaw (Left and Right)100
Up100
Down70

These settings can be saved using the Custom button on the Controller Sensitivity instrument. See the Controller Sensitivity section for more information about setting and saving custom controller settings.

This equipment is optional and may not be included in all VideoRay Pro 4 configurations.


Version: 1.07.00