Tritech International SeaSprite Operating Tips

This section describes the basic set up procedures for using the Tritech SeaSprite sonar with a VideoRay Pro 4. See the Tritech SeaSprite User Manual for additional information.

Hardware Set Up

Hardware setup for the Tritech SeaSprite requires the installation of the sonar on the ROV, and configuring the control panel.

ROV Connections

1. Mount the SeaSprite in either of the holes on the top of the float block.

2. The cable should be connected to the MAIN port on the SeaSprite.

3. Remove the 9 Pin Accessory Port Dummy Plug from the Accessory Port.

4. Install the 9 Pin connector from the SeaSprite into the Accessory Port.

5. Install the 9 Pin Accessory Port Dummy Plug in the back of the SeaSprite connector (if not already installed).

Control Panel Configuration

1. Make sure the AUX Port Selector Switch is set to the RS-485 (down) position.

Operation

Ballast the ROV following the normal buoyancy adjustment procedures.

To start the Tritech SeaSprite software, click on the Tritech Micron for SeaSprite button on the VideoRay Cockpit control bar. Follow the instructions in the Tritech SeaSprite User Manual.

This equipment is optional and may not be included in all VideoRay Pro 4 configurations.