If you do not see a menu here,
please allow blocked content
to enable scripts, which are
required to display the menu.

DOWNLOADS | TRAINING | SUPPORT | COMMUNITY | GALLERY
PRO 4
VideoRay Cockpit Guide - Control Bar - User Settings - Instrument Settings

 

 

 

 

 
Alternate Methods

There are other methods to control the display of instruments. They can be controlled individually or through the Control Bar.

See the Instruments and the Control Bar Display sections of the VideoRay Cockpit Guide for more information.

 

Instruments Settings

The Instruments Settings tab allows you to control the display properties of the instruments.

Instrument Display

The top portion of the Instruments Settings allows you to turn On or Off the display of instruments individually. Check the box next to the instrument to turn On its display. Uncheck the box next to the instrument to turn Off its display.

Instruments that are turned On individually will turn Off when using the Control Bar Off setting.

Instruments that are turned Off individually will not turn On when using the Control Bar Transparent or Opaques settings.

Depth Gauge Scale

There is also a button in the top portion of the Instruments Settings that restores all instruments to their default size and location.

The lower portion of the Instrument Settings allows you to adjust the depth gauge scale. You can set the minimum depth, the maximum depth and the grid spacing displayed on the depth gauge. These properties can be set by entering values or by clicking with the left mouse button and dragging the sliders. You can drag the grid slider to adjust the grid spacing. You can drag the top green bar to set the minimum depth, you can drag the bottom green bar to set the maximum depth, or you can drag the blue bar to change both ends of the range simultaneously

The Depth scale values can not be set to less than 0, or greater than 1000, and the grid spacing cannot be set to less than 1 or greater than 100.

If the ROV surfaces or dives outside of the range defined for the depth gauge, the depth flag will stop at the end of the gauge, but the depth number will continue to update to provide an accurate indication of the depth of the ROV.

Restoring Factory Defaults

The factory default settings for instruments can be restored by clicking on the Restore Factory Defaults button in the upper right hand corner of the Instruments Settings window.
Version: 1.03.01