Computer

The computer provides the hardware and operating system platform for VideoRay Cockpit control software and image and video editing and production.

The computer system has been set up to use the "Administrator" account and there is no password assigned.

For information about using the computer in general, see the instructions that came with it.

The computer is mounted to the control panel by a clamp. To remove the computer from the panel, loosen the yellow knob behind the computer until the computer can be pushed back enough to lift the front of the computer from the front clamp. Reverse the process to install the computer.

When installing the computer, be sure to close the computer latch. The front clamp should be connected to the computer frame and should not be connected over the computer latch

VideoRay does not recommend installing additional software on the computer unless you are familiar with the software and confident it will not interfere with VideoRay Cockpit or the computer's ports. Software that is packaged with VideoRay accessories has been tested and is approved for use.

The computer includes the following connections:

Connection	Type	Function
Power	Panasonic Power Supply	Used to connect the computer to a power source. The control panel includes two unswitched GFCI protected IEC female power outlets. One of these is available for dedicated use for the computer.
Ethernet	RJ45 female	Can be used to connect the computer to a network, or the control panel for Ethernet based accessories.
USB (Qty 2)	Type A female	Can be used to connect USB devices to the computer.
VGA Out	DB15 female	Provides a VGA video signal. Used to connect the computer to the monitor.
Serial Port	DB9 male	Can be used to connect the computer to RS-232 serial devices.

Computer specifications are subject to change without notice.