Pro 4
Pro 4, Pro 4

Basic Equipment Care

Do not abuse the VideoRay and be careful not to damage the system's components through normal use. For example, avoid letting the tether connectors come in contact with the ground where rough surfaces or dirt can damage the contacts.

Cleaning

VideoRay systems should always be cleaned after use. When used in salt water or contaminated environments, make sure to thoroughly rinse and then soak all wet components. It is especially important that you rinse the pressure sensor and allow it to drain. You must remove the float block to do this.

Use care when cleaning the pressure sensor to avoid damaging the sensor. Do not insert anything into the pressure sensor cavity, and do not apply high pressure spray to the sensor.

Storage and Transport

Always pack the system securely to make sure it is not damaged in transport.

Document Path: Pro 4 Maintenance Manual > Maintenance Best Practices > Basic Equipment Care