Strain Relief Cable Kit Replacement Procedures

Time required for this step: Approximately 3 Minutes

Tools required for this step:

• #2 Phillips Head Screw Driver

Parts involved in this step:

THR-HARNESS-P4-KIT Strain Relief Cable Kit

Quantity	Part Number	Part Description
1	THR-HARNESS-P4	Strain Relief Assembly ROV (Pro 4)
1	91772A192	Screw #8-32 x 3/8" Pan Head Phillips SS
1	98370A011	Washer #8 x 0.075" Flat SS

Steps

1. Slip the strain relief cable over the ROV tether whip and onto the term block.

2. Turn the ROV upside down and rest securely so that it does not tip over and you do not damage the vertical propeller or shaft.

3. Install the #8-32 X 3/8 inch screw and washer into the loop in the strain relief cable and screw it to the center hole near the rear of the skid.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view