Pro 4
Pro 4, Pro 4

Strain Relief Cable Kit Replacement Procedures

Time required for this step: Approximately 3 Minutes

Tools required for this step:

Parts involved in this step:

THR-HARNESS-P4-KIT Strain Relief Cable Kit

QuantityPart NumberPart Description
1THR-HARNESS-P4Strain Relief Assembly ROV (Pro 4)
191772A192Screw #8-32 x 3/8" Pan Head Phillips SS
198370A011Washer #8 x 0.075" Flat SS

Steps

  1. Slip the strain relief cable over the ROV tether whip and onto the term block.

  2. Turn the ROV upside down and rest securely so that it does not tip over and you do not damage the vertical propeller or shaft.

  3. Install the #8-32 X 3/8 inch screw and washer into the loop in the strain relief cable and screw it to the center hole near the rear of the skid.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Document Path: Pro 4 Maintenance Manual > Main Hull Tube > Replacement Procedures > 19 - Strain Relief