Pro 4
Pro 4, Pro 4 |
Skid Kit Replacement ProceduresTime required for this step: Approximately 5 Minutes Tools required for this step: Parts involved in this step: SK-PRO4-KIT Skid Kit
Steps
If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view TipIt may be easier to replace the skid by first replacing the float block temporarily and setting the ROV upside down on the float block so that it sits level. Alternately, you can set the ROV on it's thruster nozzles to replace the front screws and on it's nose to replace the rear screws. If the ballast pods were removed, they must be replaced so that the holes at the front and rear of the skid plate are closer to the ROV. The pod hinges should be toward the rear and the pods should open away from the ROV. The notches for the thruster support struts should be closer to the front of the skid. |
Document Path: Pro 4 Maintenance Manual > Vertical Motor Shield > Replacement Procedures > 18 - Skid Kit