Light Dome Replacement Procedures

Time required for this step: Approximately 2 Minutes (4 Minutes for both sides)

Tools required for this step:

• O-Ring Lubricator

Parts involved in this step:

LT-001-4 Light Dome

Quantity	Part Number	Part Description
2)	LT-001-4	Light Part Dome Industrial
2)	OR-135	O-Ring #135

Steps

Note: Both the left (port) and right (starboard) Light Domes must be replaced. Repeat these steps on both sides.

1. Use a new lubricated O-ring, or remove and lubricate the existing O-ring, and install it in the O-ring groove at the front of the horizontal thruster tube. Make sure the O-ring is seated in the groove.

2. Make sure the LED light module is seated in the thruster tube.

3. Orient the light dome so that the open end is toward the front of the horizontal thruster tube.

4. Screw the light dome onto the horizontal thruster tube until the base of the light dome touches the landing on the horizontal thruster tube. Do NOT leave a gap, and do NOT over tighten the light dome.

If the video above doesn't play in your browser, click this play icon to try an alternate method: ,

or click this manual reference icon to view an exploded view

Tips

The light dome has right-handed threads. Turn the light dome clockwise, when viewed from the front of the ROV, in order to tighten it.

The light dome diameter is relatively large compared to the thread pitch. Make sure the light dome is on straight before tightening it in order to avoid cross threading the dome onto the horizontal thruster tube.

If you cannot tighten the light dome by hand, you can use a non-slip pad, strap wrench or rubber coated pipe pliers.

Inspect the O-ring under the light dome to make sure it is in contact with the light dome all the way around. The O-ring should look solid black. If you see a lighter colored spot, that could indicate a hair or a piece of dirt and the light dome should be removed and the O-ring and sealing surfaces inspected.