Float Block Kit Replacement Procedures

Time required for this step: Approximately 2 Minutes

Tools required for this step:

• None

Parts involved in this step:

FB-001-KIT-P4 Float Block Kit

Quantity	Part Number	Part Description
1	VR-PRO4-06-0001	Float Block Assembly - Filled (Pro 4)
1	91744A542	Screw 1/4"-20 x 1" Thumb SS
1	92141A029	Washer 1/4" x 0.05" Flat SS
2	FB-PLG-ACC-KIT	Float Block Assembly Insert Small

Steps

1. Orient the float block on top of the ROV and align the large through-hole in the float block with the thruster and the small hole with the termination block stud.

2. Place the float block in position on the ROV.

3. Secure the float block with the 1/4-20 X 1-1/4 inch float block retaining screw and 1/4 inch washer.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Tip

If accessories are to be attached to the ROV accessory port, it might be easier to connect them to the accessory port before the float block is replaced.