ROV Wire Harness Removal Overview

Skill level recommended: Advanced

Total time required: Approximately 57 Minutes

Tools required:

• #2 Phillips Head Screw Driver
• 7/16 Inch Open End or Socket Wrench
• Strap Wrench or Rubber Coated Pipe Pliers
• 5/16 Inch Open End Wrench or Nut Driver
• 5/16 Inch Open End Wrench or Nut Driver (Additional)
• Wooden Dowel Rod 3/8" x 12"
• Dental Pick or equivalent

The following components must be removed:

• Float Block Kit
• Skid Kit
• Light Dome
• LED Light Module Assembly
• Horizontal Thruster Propeller Kit (Left and Right)
• Horizontal Thruster Nozzle Kit
• Horizontal Thruster Cone Assembly
• Dome Retaining Rings and Main Hull Rods
• Front Dome
• Front Hull Ring Assembly with Camera
• Rear Dome
• Rear Hull Ring Assembly
• Desiccant Pack
• ROV Board Set
• ROV Wire Harness