Pro 4
Pro 4, Pro 4

Horizontal Thruster Nozzle Kit Removal Procedures

Time required for this step: Approximately 2 Minutes (4 Minutes for both sides)

Tools required for this step:

  • None

Parts involved in this step:

VR-PRO4-08-0001 Horizontal Thruster Nozzle Kit

QuantityPart NumberPart Description
2)GTO-017-ASSMThruster Nozzle Assembly
2)GTO-012Thruster Nozzle Part Nut (GTO, Deep Blue, Pro 4)

Steps

Note: Both the left (port) and right (starboard) Horizontal Nozzles must be removed. Repeat these steps on both sides.

  1. Unscrew the horizontal thruster nozzle nut from the horizontal thruster cone.

  2. Once the horizontal thruster nut is removed, slide the horizontal thruster nozzle assembly off of the horizontal thruster cone.

If the video above doesn't play in your browser, click this play icon to try an alternate method: ,

or click this manual reference icon to view an exploded view

Tips

The horizontal thruster nut has right-handed threads. Turn the thruster nut counterclockwise, when viewed from the rear of the ROV, in order to loosen it.

If you cannot turn the horizontal thruster nozzle nut, grasp the horizontal thruster nozzle assembly and nut and turn them both at the same time. This should free the nut enough that it can be turned by hand.

Document Path: Pro 4 Maintenance Manual > Wire Harness > Removal Procedures > 6 - Horizontal Nozzle