Vertical Thruster Kit Removal Procedures

Time required for this step: Approximately 5 Minutes

Tools required for this step:

• 1-1/4 Inch Open End or Deep Socket Wrench

Parts involved in this step:

VR-PRO4-02-KIT Vertical Thruster Kit

Quantity	Part Number	Part Description
1	VR-PRO4-02-0001	Thruster Assembly Vertical Drive Train Brushless (Pro 4)
1	VTH-001-GY	Thruster Part Vertical Cone (Pro 4)
1	VTH-003-GY	Thruster Part Vertical Cone Spacer (Pro 4)
1	OR-020	O-Ring #020
1	OR-118	O-Ring #118

Steps

1. From inside the main hull, cut the cable tie that holds the wires to the vertical thruster motor.

2. From inside the main hull, disconnect the wires from the vertical thruster motor.

3. Unscrew the vertical thruster dome nut from the top of the vertical thruster drive train.

4. Remove vertical thruster motor spacer from the top of the vertical motor drive train.

5. Pull the vertical drive train from the inside of the main hull.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view