Pro 4
Pro 4, Pro 4

Dome Retaining Rings and Main Hull Rods Removal Procedures

Time required for this step: Approximately 5 Minutes

Tools required for this step:

Parts involved in this step:

MHU-002-GY-KIT Dome Retaining Rings and Main Hull Rods

QuantityPart NumberPart Description
2MHU-002-GYMain Hull Part Dome Retaining Ring (Pro 4)
2MHU-005Main Hull Part Rod
491855A271Nut #6-32 x 5/16" Acorn SS
291831A007Nut #6-32 x 5/16" Nylock
4561-06012Washer #6 Insulating Nylon

Steps

  1. Unscrew the 6-32 acorn nuts from the main hull rods at the rear of the ROV.

  2. Unscrew the 6-32 Nylock nuts from the main hull rods at the rear of the ROV.

  3. Remove the rear dome retaining ring from the main hull rods. Make sure to keep track of the plastic inserts.

  4. Remove the front dome retaining ring and main hull rods from the front of the main hull.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Tip

It is usually best to leave the main hull rods in the front dome retaining ring unless you are replacing the retaining ring or rods.

Document Path: Pro 4 Maintenance Manual > Termination Block > Removal Procedures > 8 - Dome Retaining Rings