Pro 4
Pro 4, Pro 4

Camera Tilt Servo Motor Assembly Removal Procedures

Time required for this step: Approximately 5 Minutes

Tools required for this step:

Parts involved in this step:

MAR-012 Camera Tilt Servo Motor Assembly

QuantityPart NumberPart Description
1MAR-012Camera Package Tilt Servo (Pro 4)
291772A106Screw #4-40 x 1/4" Pan Head Phillips SS
298017A610Washer #4 x 0.03" Flat SS
1MAR-014Camera Part Tilt Drive Gear (Pro 4)

Steps

  1. Unscrew the two 4-40 X 1-4 inch Phillips head screws that hold the camera tilt servo motor into the camera mount base. Make sure to keep track of the washers.

  2. Pull the camera tilt servo motor from the camera mount base.

  3. Unsolder the camera tilt servo wires from the camera interface board.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Tips

Some camera tilt servo motors have shims underneath of the servo to align the gears. If your camera tilt servo motor has shims, make sure to keep track of the shims and replace them when replacing the motor.

Document Path: Pro 4 Maintenance Manual > Camera > Removal Procedures > 11 - Camera Tilt Servo