Pro 4
Pro 4, Pro 4

Horizontal Thruster Cartridge Seal Removal Procedures

Time required for this step: Approximately 2 Minutes (4 Minutes for both sides)

Tools required for this step:

  • None

Parts involved in this step:

CS-KIT-BL(h) Horizontal Thruster Cartridge Seal

QuantityPart NumberPart Description
1CS-KIT-BL(h)Cartridge Seal Assembly Blue
190295A090Washer #6 x 0.06" Flat Nylon (Thick)

Steps

Note: The following step-by-step instructions apply to one side. Repeat these steps on both sides if you plan to remove both Horizontal Cartridge Seals.

  1. Pull the horizontal cartridge seal off of the horizontal thruster shaft. Make sure to keep track of the cartridge seal washer inside the outboard end of the cartridge seal.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Tip

If the horizontal cartridge seal is hard to pull free from its seat, twist the cartridge seal to free it for easier removal.

Document Path: Pro 4 Maintenance Manual > Horizontal Drive Train > Removal Procedures > 2 - Horizontal Cartridge Seal