Camera Mount Cover Removal Overview

Skill level recommended: Advanced

Total time required: Approximately 58 Minutes

Tools required:

• #2 Phillips Head Screw Driver
• 7/16 Inch Open End or Socket Wrench
• 5/16 Inch Open End Wrench or Nut Driver
• 5/16 Inch Open End Wrench or Nut Driver (Additional)
• Wooden Dowel Rod 3/8" x 12"
• #1 Phillips Head Screw Driver
• #0 Phillips Head Screw Driver
• Soldering Iron

The following components must be removed:

• Float Block Kit
• Skid Kit
• Horizontal Thruster Propeller Kit (Left and Right)
• Horizontal Thruster Nozzle Kit
• Dome Retaining Rings and Main Hull Rods
• Front Dome
• Front Hull Ring Assembly with Camera
• Camera Assembly
• Camera Lens-Focus Cam Gear
• Camera Interface Printed Circuit Board
• Camera Tilt Servo Motor Assembly
• Camera Mount Base Assembly
• Camera Focus Servo Motor Assembly
• Camera
• Camera Mount Cover