Pro 4 Ultra
Pro 4 Ultra, Pro 4 Ultra |
Operator Control ConsoleThe Operator Control Console provides power, communications and a video interface between the surface and the ROV through the tether. The computer, which runs VideoRay Cockpit software to control the ROV, is housed in the Operator Control Console along with a second display monitor . Computer models may vary depending upon purchased configuration, and the second monitor is optional. Operator Control Console Power SpecificationsThe VideoRay Pro 4 Ultra operates on typical residential power in the range of 100-240 Volts AC, 50,60 Hz. This can be provided from the land-based grid, a generator, or a battery with an inverter (optional). The typical power requirements for operating from a generator or inverter are 800 Watts continuous minimum. The system includes a GFCI (Ground Fault Circuit Interrupter) / Circuit Breaker to protect the operator. There is one universal IEC power outlet on the back of the Operator Control Console. this outlet is protected by the GFCI. The GFCI must be on to use this outlet, but the Operator Control Console power switch does not need to be on. The power in the tether is 48 Volts DC. The procedures for testing the circuit safety component can be found in the Pre-Dive Preparations section of the Quick Start Instructions. Do not block the Operator Control Console fans. Blocking the fans can lead to overheating and component failure. Display Monitor Tilt Armhe Display Monitor Tilt Arm on the left side of the Operator Control Console can be used to adjust the angle of the Operator Control Console lid and monitor. To adjust the angle of the monitor, loosen the locking collar, adjust the lid to the desired angle and tighten the locking collar. Make sure to loosen the display monitor tilt arm before closing the Operator Control Console lid, and be careful when closing the lid to avoid damaging the computer or monitor or pinching any cables. |
Document Path: Pro 4 Ultra Operator's Manual > Equipment Guide > Control Panel