Connections Summary

Connections Summary - see the descriptions below the figure for each numbered connection.

1. The male tether connector on the ROV is connected to the female connector on the tether.

2. The ROV strain relief cable is connected to the strain relief webbing on the tether.

3. The male tether connector is connected to the female tether connector on the Operator Control Console.

4. The USB connection on the computer is connected to the USB PC connection on the Operator Control Console using the supplied USB cable.

5. The hand controller is connected to one of the USB ports on the computer or Operator Control Console.

6. The computer power cord is connected from the computer power cord receptacle to the GFCI protected IEC outlet on the Operator Control Console using the supplied country specific adapter cable.

7. The Operator Control Console power cord is connected from the Operator Control Console IEC power cord receptacle to a suitable power source (100-240 Volts AC, 50, 60 Hz) using the supplied country specific power cord.

8. The Analog Video Out connector on the Operator Control Console can be connected to another video display using the supplied cable. Some monitor models may have a permanently attached RCA composite male cable, or may not have this connection at all. If this cable is not used, do not leave it connected to only one side. This could result in poor video quality.