Network Remote Configuration

The Network Remote tab allows you to specify the network settings for remote operations.

See the Using Network Remote Operations section of the Operations Guide and Remote Connect for more information.

Configuration

if "Allow this system to act as a server" is checked, a distant client system can connect to this system and operate an ROV that is connected to this system.

If you want to connect to a server as a client, you must enter the server's IP address in the "Connect to:" fields.

The IP address must be visible from the Internet. If the server is behind a firewall, appropriate access mut be enabled.

The ports must be set as follows: The Negotiation port should be the same on the client and server, the Input port on the client should match the Output port on the server, and the Output port on the client should match the Input port on the server.