Command: vr_refresh

The vr_refresh command is used to update the firmware on a module.

Use

vr_refresh [OPTIONS] [SINGLE_HEX_FILE_NAME]

• [Options] - See the table below
• [SINGLE_HEX_FILE_NAME] - The file name of the firmware update, including its path.

OPTION	Alternate	Argument(s)	Description	Default
-?	--help		Display this help information
--version			Display the Version Number
-c	--com	Com_Port_Name	Com port to use	dev/ttyUSB0
-i	--id	Node_ID	Node ID of the Module to update, use 255 for broadcast to all nodes	255
--sn		Serial_Number	The Serial Number	any
--block_size		Block_Size	The block size of the firmware	1024
--timeout		Timeout	Set the connection Timeout in mS	1500
--skip_bootcheck			Skip sending a bootcheck command
--skip_initial_reset			Skip sending an initial reset command
-v	--verbose		Output verbose diagnostics
-r	--reset		Reset device upon completion
--UNLOCK			Allow programming of the bootloader
---input_file		Filename	The file name of the firmware update file, including its path

Some of the options use two dashes "--," not a long dash